Hi

I am a new member and have started to play around with dos again after going astray for many years. In the past I have used A86 and now would like to use fasm.
The source snippet below works fine in A86 and lea points to ds:0102 which is where the start of image resides. But in fasm lea points to ds:0066 which is wrong. It looks as though I am using the wrong syntax. Help please and what is the best learning tool for fasm syntax.

percy


;-------------------------------------------------------------------------
org 0100 ;100h bytes for psp

jmp start
;
image: db 1,2,3,4,5
;..............................................................

start:
;
lea si,[image]
;
;......exit.................................................................
int 20h
;----------------------------------------------------------------------------------------------------------------------

You supplied 100 decimal as argument of "org", should be hex

vid

Yes that was the problem thank you. The following 'h' was not needed with A86 so I will have to watch that.

percy